Duct Flexible Connector Machine, Roll Forming Machine
Roll Forming Machine for Production air duct flexible connectors
The Air duct flexible duct connector joint is in order to isolate vibrations caused by air handling units, fans or other equipment connected to air ducts, to install a flexible duct connector joint between the outlet of these devices and the air duct. It is with an airtight and flexible cloth, with good weathering qualities and one which will withstand the temperatures inside and outside the duct. Duct being generally made of steel, the main difficulty is to fasten the cloth to it in order to obtain a perfectly airtight joint. Our flexible duct connector manufacturing machines are just for production this belt of a strip of treated cloth, attached on both sides to strips of galvanised steel.
There have two lines for this belt production. Punching coil line is to obtain the pre-punched holes strip, with width adjustable the roll forming line to complete the production. The reason two lines for production the belt coil is because of the too much different efficiency of these two lines, and the investment cost. So this solution is the best choice presently.
- Metal sheet Punching Coil Line
Brief introduction
This punching holes line is to prepare the punched holes coils, for roll forming raw material. The whole line is consisted of one set de-coiler, punching machine with special hole punching moulds, material feeding device and one set re-coiler, etc.
Punching coil line technology flow
De-coiler ---- material feeder ---- punching (punching moulds) ----- re-coiler
Punching coil line main parameters
| ITEM |
CONTENT |
| product size |
according to customers |
| working speed |
3-5m/min |
| Punching machine |
25T |
| Material step feeding device |
Mechanical type |
| suit for material size |
Both sides strip thickness range: 0.3-0.5mm |
| Dimension |
4500*1200*2000mm |
- Duct Flexible connector Roll Forming Line- Belt
Brief introduction- Flexible connector Roll Former machine
The metal coils prepared by the holes punching line and the fireproof material are as the feeding material for the belt roll former. After these two strips combined roll forming by the roll former, the completed belt can be obtained. Normally the canvas is as the fireproof flexible raw material.
The belt roll forming line / Air duct flexible duct connector joint is consisted of de-coiler, main roll forming machine and re-coiler. The main Duct Flexible Connector roll forming machine can be designed according to client’s request, whether to adopt the fixed width belt or adjustable width belt.
Main parameters- Flexible connector Roll Former machine
| ITEM |
CONTENT |
| working speed |
6-7m/min |
| Forming roller stations |
12 stations x 2 (double line stations on main roll forming machine) |
| Roller material |
CR12MoV as raw material ,hardness HRC60-62 after treatment, |
| Shaft material |
Quality steel Ф40mm, 45# steel |
| Main motor |
3kw + 1.5kw |
| suit for material size |
- Flexible fireproof Fabric width range (middle side): 50----300mm(2”-12”),
- metal strip width range: 40—110mm(1.5”-4.5”);
- metal strip thickness range: 0.3-0.5mm(30-26ga.),
NOTE:
It can be custom made according client’s request.
|
| Main machine sizes |
3500*1300*1300mm |
Flexible Duct connector Application
Air Duct Flexible Canvas Connector For HVAC System is designed to enable flexible joints of any size to be easily and economically formed in the factory or on site. Flexible joints are installed between fans(or similar equipment) to prevent the transmission of vibration, noise and rattles to the remainder of the air conditioning system.
Product Tags:
|
|
25T Flexible Duct Connector Machine 3m/min - 5m/min Roll Forming Machine Images
|
